[TenTec] Omni VI+ Keying Question

[David E. Shelton]

Jerry,
You beat me to that comment. I done that to an old Omni V I had because you
could not turn it off like in the Omni VI+.
73,
David, N4IN

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Dr. Gerald N. Johnson
Sent: Sunday, October 01, 2006 6:31 PM
To: tentec at contesting.com
Subject: Re: [TenTec] Omni VI+ Keying Question

On Sun, 2006-10-01 at 18:04 -0500, Don and Diana Cunningham wrote:
> Hi again,
> On my recently acquired Omni VI+, I am experiencing problems keying my 
> TL-922A amp.  The amp has been modified so that the keying line requires 
> sinking only 10 VDC @ 10 ma, so a relay should handle it easily!  I have 
> turned the relay on in the menu, but either "on" or "off", the line is
keyed 
> all the time.  Unplugging the cable unkeys the amp, so the cable is not 
> shorted.  Cable also works fine with the Orion II.  Is there something 
> common I should look for, or is it Ten Tec service calling time??  I just 
> don't want to overlook something obvious before calling Paul.  Loving the 
> rig so far!!
> 73,
> Don, WB5HAK 
> 
My guess is that thee PA keying relay has been quieted with a match
stick holding it closed. Remove the match stick.
-- 
73, Jerry, K0CQ,
All content copyright Dr. Gerald N. Johnson, electrical engineer

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec