[TenTec] Orionll 566AT Main Rx Hang Problem

[Ron Castro]

Tony:

A lot of things could be responsible for that problem.  If the firmware got 
corrupted, reloading would probably fix the problem, but even if not, 2.037j 
is an excellent upgrade to do.  If that doesn't fix the problem, I would 
call Ten Tec and let them walk you through the fix.

Ron N6AHA

----- Original Message ----- 
From: "EI6DL" <ei6dl at eircom.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Wednesday, October 25, 2006 6:04 PM
Subject: [TenTec] Orionll 566AT Main Rx Hang Problem


> Hello! All.
>
> Have any of you Ten-Tec Orion ll 566 owners come across this problem ? The 
> Main Rx on my Orion ll 566AT running V2.032 has hung for no apparent 
> reason on more than one occasion. Checking the Sub Rx and it  receives 
> fine all the time that this is happening . On the Main Rx there is only 
> band noise and no audio modulation and no signal modulation showing on the 
> Sweep display. Switching  On and  Off the rid has managed cleared this but 
> not always . Also having  left the rig off for a while and switching it on 
> again has cleared it .
>
> I have been thinking of downloading the latest updated software V2.037j 
> in the hope that that may remedy the problem ??
>
>
>
> 73'es
>
> Tony  EI6DL.
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>