[TenTec] Sidetone Level with 2.037j

[Ron]

Klaus,
The side tone level may be different than before... I'd have to reload the
2.034 to be sure, but on my O2 the side tone level seems adequate from the
front jack in the head phones or from the internal speaker.  I'm running
S-Tone @ 32 and it is about right for me in the head phones.  I did do a
master reset when I installed version 2.037j.
Ron
KA7U

-----Original Message-----
From: tentec-bounces at contesting.com
[mailto:tentec-bounces at contesting.com]On Behalf Of Klaus Heintzenberg
Sent: Friday, September 08, 2006 9:48 AM
To: tentec at contesting.com
Subject: [TenTec] Sidetone Level with 2.037j


O2 S/N 02C10436

On my O2 with firmware 2.037j the sidetone level appears to be
too weak for my taste.
Used to have the sidetone level set to 50% for the front panel
headphone connector. This is now much to weak. Even cranking it up to
100% does not help much.
Now I must use the rear speaker output to reach a comfortable level.
Do others notice the same?

73, Klaus



_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec