[TenTec] ORION2_LOGGING_PROGRAM_SPOTS

[Carl Moreschi]

When using my N4PY Orion control program,  the mode is figured out from the
frequency.  If the frequency is in the CW portion of a band, the mode is CW.
If the frequency is in the SSB portion, the mode is USB for bands above 7
mhz, and LSB for bands below 7 mhz, except for 5 mhz which is always USB.
The filter selected is the default filter you define in the program for each
mode.  I have a free DX Spots program that works with all my control
programs very nicely.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "George" <goofyham at highstream.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Sunday, September 17, 2006 9:25 AM
Subject: [TenTec] ORION2_LOGGING_PROGRAM_SPOTS


> Can someone tell me how the Mode and selectivity, width, are selected when
I
> click on a packet spot???
> Who tells the O2 whether to use UCW or LCW and the filter width.
> I'm racking my brain trying to find out where this info comes from.
> Thanks.
> George
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec