[TenTec] N4PY New Omni V chips

[Carl Moreschi]

Ryszard Borkowski

I am unable to send an email to you.  The email is rejected because it says
access is denied by the policy analysis functions.

Maybe you need to add my n4py at arrl.net to your address folder?

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "Carl Moreschi" <n4py at arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Thursday, September 21, 2006 8:52 PM
Subject: [TenTec] N4PY New Omni V chips


> I have made up a new batch of Omni V chips.  These chips are what I am
> calling my Omni V.9 version 2 chips.  In this chip, there is no longer any
> need to do the extensive serial port mod that was required for serial port
> operation in my original Omni V.9 chip.  The only thing needed for this
chip
> is to install it and relabel 3 keys on the Omni V keyboard.
>
> New functions for the Omni V.9 version 2 chip are:
>
> Up/Down arrow function for quick split
> Revised tuning rates by mode
> Icom CI-V serial port operation
> Memory tune operation
> Band Stacking Registers
> Direct Frequency Entry
> Memories that hold split frequencies
>
> I am now taking orders for the chip.  This chip is $35.
>
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec