[TenTec] GFCI problem when running high power
James C. Owen, III
k4cgy_list at yahoo.com
Thu Apr 5 10:42:00 EDT 2007
Hi John,
If you can make your antenna resonate on 40M (about 63') your
problem might go away. Just make a temp one using coax and see
what happens. I have a similar problem on 75M but it's due to the
antenna being too close to the RF sensitive devices. My motion
light's outside go on with over 25 watts and over 10 watts shuts
down the modem on this computer but not on the laptop. Antenna
though is only about 5' from the lights and about 10-12' from the
computer.
73 Jim K4CGY
--- John K Gotwals <john at gotwals.com> wrote:
> I am using an Orion to drive my Drake L-4B, and I operate
> mostly on 40
> meters. My antenna is a 110 feet long dipole, center-fed with
> open-wire feed
> line, and elevated about 30 feet with the support for one end
> attached to
> the house chimney. My shack is in a 2nd floor bedroom, and the
> circuit
> breaker panel is located in the basement at the opposite end of
> the house.
> The house has a brick exterior, and one end of the antenna is
> only a few
> feet from the shack.
>
____________________________________________________________________________________
Now that's room service! Choose from over 150,000 hotels
in 45,000 destinations on Yahoo! Travel to find your fit.
http://farechase.yahoo.com/promo-generic-14795097
More information about the TenTec
mailing list