[TenTec] OMNI VII What if...about 'Flash Update Mode'

[joel hallas]

On the Omni 7s I've been using, the firmware update works fine without 
booting with the 0 key held.

It runs great via the serial cable with the radio just on and in loacal 
mode. It doesn't seem to work if RIPing with the remote PC.

The latest adds the bar-graph for SWR, now possible to easily tune that 
manual tuner!

GL & 73, Joel

Joel R. Hallas, W1ZR

Carl Moreschi wrote:

>After booting the radio with the 0 key held, just go ahead and run update
>anyway.  I had this happen to me once and everything straightened itself out
>after I re-loaded the firmware using the tentec update program.  The update
>program didn't like the "radio not programmed" state when the update
>finished.  So I ran update a second time and all has been well since.  I am
>suspicious that a static spark from my finger may have caused all this but
>I'm not sure.
>
>Carl Moreschi N4PY
>121 Little Bell Drive
>Bell Mountain
>Hays, NC 28635
>----- Original Message ----- 
>From: <dbp at tds.net>
>To: "Tentec reflector" <tentec at contesting.com>
>Sent: Saturday, April 07, 2007 9:42 AM
>Subject: [TenTec] OMNI VII What if...about 'Flash Update Mode'
>
>
>  
>
>>Hi-
>>What if I want to update the flash memory, but when I go thru the sequence
>>    
>>
>to enter the Flash Update Mode, it will not indicate "Flash Update Mode"?
>  
>
>>What if at turn on the rig reverts to "Radio not programmed" after
>>    
>>
>receiving an initial message: "Retreiving Boot Setup"?
>  
>
>>What if using the "Master Reset" sequence has no effect?
>>
>>A little glitch to get started.
>>
>>73 de Dave
>>_______________________________________________
>>TenTec mailing list
>>TenTec at contesting.com
>>http://lists.contesting.com/mailman/listinfo/tentec
>>    
>>
>
>_______________________________________________
>TenTec mailing list
>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>  
>