[TenTec] Slaving radios

[Carl Moreschi]

Not yet.  I should have around it handling the audio around May 1.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "Alan Sewell" <alan.n5na at gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Friday, April 20, 2007 11:33 PM
Subject: Re: [TenTec] Slaving radios


> Carl,
>
> Is your Omni VII program handling the audio over the ethernet connection
> now?  The last I heard you were working on it.
>
> 73,
>
> Alan  N5NA
>
> http://www.tentecwiki.org
>
>
>
> Carl Moreschi wrote:
> > You can do it several ways.  If the O7 is near your computer, you can
just
> > connect a serial port from the computer to the O7.  I think the limit on
a
> > serial cable is about 50 feet.  If the O7 is 1200 feet from the shack,
you
> > can run an ethernet cable from the computer to the O7.  My N4PY software
> > will then control the radio very nicely.  My webpage is at www.n4py.com
> >
> >
> > Carl Moreschi N4PY
> > 121 Little Bell Drive
> > Bell Mountain
> > Hays, NC 28635
> >
> >
> >
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec