[TenTec] Article on 40th anniversary of Ten-Tec

[Frank Holladay]

Why was there no mention of the tool and die work?  The first dealing I had 
with Ten-Tec was when the company I worked for had a set of three multi 
cavity injection molds for plastic marker parts.
Regards,
Frank, K4VMO
----- Original Message ----- 
From: <K5XS at aol.com>
To: <tentec at contesting.com>
Sent: Monday, December 17, 2007 1:52 PM
Subject: Re: [TenTec] Article on 40th anniversary of Ten-Tec


>
> Thanks, Scott.  Nice piece.
>
> I found this surprising:  "Our primary customer is the amateur radio
> operator," Jack Burchfield, president of Ten-Tec and an employee for all 
> 40  years,
> said. "We also supply receivers that are used by commercial and 
> government
> users."
>
> I had assumed somehow your government business was bigger than amateur
> radio, but I guess not.
>
> Merry Christmas to everyone there.
>
> Bernie Skoch
> K5XS
>
>
> In a message dated 12/17/2007 1:29:53 P.M. Central Standard Time,
> sales at tentec.com writes:
>
> This  appeared in the Sevierville newspaper, the Mountain Press, on 
> Sunday:
>
> http://www.zwire.com/site/news.cfm?brd=1211
>
> Scroll down  towards the bottom of the page.
>
> Scott  Robbins
> W4PA
>
>
>
>
>
>
>
> **************************************See AOL's top rated recipes
> (http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004)
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>