[TenTec] OMNI6 PLUS Alignment procedure needed

[Bob McGraw - K4TAX]

I too am puzzled.  The manuals that I have received from Tentec with the 
equipment that I purchased has a written circuit description, a schematic, 
and a component layout.  And where appropriate, a written alignment 
procedure.

If you don't have a manual, they are available for purchase from Tentec. 
When I sold my equipment, also supplied, to the buyer, the manual that came 
with the equipment.  It often contained my pencil notes, thus they can be 
easily erased, and figures from my operational or alignment notes or 
performance data.

What's missing?

73
Bob,. K4TAX


----- Original Message ----- 
From: "John Cox" <jecox at tri-lakes.net>
To: <wb2vuf at arrl.net>; "Discussion of Ten-Tec Equipment" 
<tentec at contesting.com>
Sent: Saturday, December 29, 2007 10:03 AM
Subject: Re: [TenTec] OMNI6 PLUS Alignment procedure needed


>I have an Omni 6 and an Omni 6+ and the manuals seem to be pretty detailed
> to me.  Most of the manual is devoted to descriptions of componets and
> service information.
> What is it that I am missing here?  I would think that with the 
> information
> supplied that any person with an electronics back ground could service 
> them.
>
>