[TenTec] Omni VI serial control

[Carl Moreschi]

No, you do not need RTS or CTS.  The omni VI is completely CI-V compliant.
You need to set the correct baud rate and the correct CI-V address in your
program that is trying to access the Omni VI.  These values are available in
the Omni VI menus.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "Tod Glenn" <n7wd at cordite.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Monday, January 15, 2007 10:10 PM
Subject: [TenTec] Omni VI serial control


> Hi all
>
> I am trying to set up computer control for my Omni VI.  I've got a
> USB to CI-V converter which works fine with my Icom, but I can get it
> to work with the Omni.  I though the Omni used Icom CI-V.  Any
> suggestions?  Do I need RTS or CTS?
>
> Thanks
> ----
> Tod Glenn
> N7WD
> SKCC #1444
> ARCI #12420
> FISTS #12134
> NAQCC #1283
>
> n7wd at cordite.com
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec