[TenTec] Orion II key click report

[Ken Brown]

I used to run a Kenwood TS-440, driving a SGC SG-500 amplifier. The 
SG-500 requires about 55 to 60 watts of drive for full output. It has 
protection circuitry, of various kinds. There are probably about a half 
dozen conditions that will shut the amplifier down to prevent damage, 
and there is an input attenuator, about 3 dB, that automatically 
switches in if you overdrive the amplifier. You don't want to overdrive 
the amplifier and you don't want that attenuator automatically switching 
in on every leading CW element of a transmission. Turning the RF output 
down on the TS-440 results in a funny sort of slow rise envelope. I 
investigated the possibility of adjusting the ALC (or mis-adjusting it) 
so that it would have a proper keying envelope at 55 watts output, and 
probably could have done that. Then I would not be able to get the full 
100 watts out of the TS-440 when I wanted it, running without the amplifier.

So, I made a power attenuator out of a bunch of 2 watt carbon 
composition resistors. I don't recall the exact values. It is a T 
network with about 2.5 to 3 dB attenuation, and four or five, two watt 
resistors in parallel for each of the three elements of the T. It could 
probably dissipate 30 watts continuously in air, and at CW duty cycle 
would be fine dissipating 50 watts. Just to be sure, I built it in a one 
quart paint can filled with mineral oil. When using the SG-500 and 
transmitting and receiving on a single antenna the attenuator was in 
line for both transmit and receive. My keying envelope was good, and the 
attenuation was not even noticeable in receive.

Perhaps a better setup would be to have the power attenuator in the 
input circuitry of the amplifier, after the input/bypass switching 
relay. If you could get the right carborundum, or other non-inductive 
power resistors, to make the right sized (both in attenuation and power 
rating) pad, it might fit inside the amplifier.

If you do a google search on " t pad attenuator calculator " you'll get 
plenty of results. The first one on the list worked for me.

DE N6KB
>>
>>     
> How much drive power does the PA take? The Orion is a bit notorious for
> setting power only with the ALC while keeping drive up (no adjustment
> for drive in CW mode) which tends to make a sharp corner when the rising
> power gets to the power setting, instead of the desired rounded corner.
> Slower rise time doesn't force that top corner rounding. You might try
> inserting attenuation between the Orion and the PA to allow the Orion to
> run full tilt so the top corners on the envelope are rounded.
>
> Scopes are notoriously poor about triggering on modulation envelopes,
> they'd rather trigger on the individual sinewaves of the carrier.
> Triggering on the audio or the key closures is more reliable.
>
> 73, Jerry, K0CQ
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>