[TenTec] Frozen display on Omni V.9

[John T. Fleming]

Bob,

I don't have nor have ever owned an Omni V.  But as a shot in the dark, try
reheating the connection pins for the encoder.  I have an Orion I and have
had trouble twice with the encoder for the RIT/XIT.  Both times it cured the
problem.  With the Orion, pressing the encoder resets things to "0".  I look
at it as an easy "try" before totally replacing the encoder.  Good luck.
73,
John

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Bob Towers
Sent: Tuesday, July 31, 2007 10:03 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Frozen display on Omni V.9

Bob McGraw - K4TAX wrote:
> Could this be one of those "3rd party" software glitches?
> 
> A full reset may correct the issue or maybe return to the original Tentec 
> issued software which did not encounter the concern.
> 
> 73
> Bob, K4TAX
> 
>Thanks, Bob, for your suggestions. The full reset didn't do the trick, 
by the way.

I'm not sure about the software. The V -> V.9 mod involves replacement 
of the main EPROM ie a change of the firmware. There are enough V.9 
modded rigs out there to have shown up this problem already, if that had 
been the cause.

73

Bob
MM0RKT
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec