[TenTec] OmniVII band output info??

[Carl Moreschi]

It's just that there's so many thing that computer programs such as mine can
make simple and fast.  Like when trying to call a DX station and suddenly he
announces he is listening up 5.  All I have to do is press my "up" key
followed by the "5" key.  That makes my VFO B by 5 khz above my VFO A and
turns on split.  All in one operation.  I am almost always the first to call
when this happens.  Or when I change bands everything gets restored to the
last values I had on that band even things like power output settings,
antenna settings, attenuators, preamps, and so on.  And it's great to have
separate band register buttons by mode.  I have a full set for CW, another
set for SSB, and a third set that can be defined for SWL bands or RTTY
sub-bands.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, North Carolina 28635

----- Original Message -----
From: "Dale Martin" <kg5u at hal-pc.org>
To: "'Discussion of Ten-Tec Equipment'" <tentec at contesting.com>
Sent: Thursday, March 08, 2007 11:59 AM
Subject: Re: [TenTec] OmniVII band output info??


>
>
> That's too bad....not you and your software, Carl, but the fact that the
> band data is not available on the back of the radio.
>
> Forgive me if I sound a but retro here, but.....
>
> I think I will stay with my Omni VI's where my radios control the antenna
> switching and bandpass filters.....without having to have the computer
> turned on.
>
>
> 73,
> Dale, kg5u
>
> >
> > There are no band outputs on the back of the Omni VII.
> > Computer control is the answer.  My N4PY software will have
> > full function for this.
> >
> >
> > Carl Moreschi N4PY
> > 121 Little Bell Drive
> > Bell Mountain
> > Hays, North Carolina 28635
> >
> > ----- Original Message -----
> > From: <k7gt at charter.net>
> > To: <tentec at contesting.com>
> > Sent: Thursday, March 08, 2007 11:22 AM
> > Subject: [TenTec] OmniVII band output info??
> >
> >
> > > Hi gang,
> > >
> > > A question for those with OmniVIIs. I reviewed briefly the OmniVII
> > > manual
> > that is
> > > on-line and couldn't locate an output for band information. Both the
> > OmniVI and Orion
> > > have that info available on the back panel (so did the
> > Corsair I and
> > > some
> > earlier rigs).
> > > Has this very useful feature been dropped or does one have to go
> > > through
> > computer
> > > control to get that info?
> > >
> > > Otherwise it looks like the VII may be in my future.
> > >
> > > Allan K7GT
> > >
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec