[TenTec] Orion 1QRP

[STEVEN KLINE]

Tim,

I am running Version 1.372 on my ORION and performed measurements on
80-10 meters into a dummy load, measured with an Array Solutions (WX0B)
Power Master watt meter.  The ORION power was set to 1 on the power
menu.  Measured observations:
80M - 4W
40M - 4W
20M - 3W
15M - 3W
10M - 3W

QRP is defined as 5 watts or less I believe.  Perhaps your watt meter
accuracy is just a little off?  I would conclude from my measurements on
my ORION and into my dummy load that I could operate QRP without
reservation if desired.

Good luck in the contest.

Steve Kline - W5JK



-----Original Message-----
From: tentec-bounces at contesting.com
[mailto:tentec-bounces at contesting.com] On Behalf Of k3hx at juno.com
Sent: Monday, March 12, 2007 12:07 PM
To: tentec at contesting.com
Subject: [TenTec] Orion 1QRP


The ARCI QRP contest is due this Sunday and I would like to use 

my Orion (software ver 1.372) but am unable to get the power down far 

enough using the PWR button and MULTI knob.

I'm loathe to use an attenuator.  Is there a way to run down the

drive?

Be Well,

Tim


________________________________________________________________________
Interested in getting caught up on today's news?
Click here to checkout USA TODAY Headlines.
http://track.juno.com/s/lc?s=198954&u=http://www.usatoday.com/news/front
.htm?csp=24


_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec