[TenTec] Orion display readout

[Ron Castro]

Giuseppe:

Do the RIT and XIT controls work OK?  When they are off does RIT and XIT in 
the display for Main, and RIT for Sub all show "0"?  This could be a 
firmware problem or maybe the RIT/XIT encoder has gone bad. You may want to 
try a Master Reset, or reload the firmware from the Ten Tec website.

      Ron N6IE
 www.N6IE.com
(Formerly N6AHA)

----- Original Message ----- 
From: "Giuseppe Crosta" <crosta at aero.polimi.it>
To: <tentec at contesting.com>
Sent: Monday, March 12, 2007 9:18 AM
Subject: [TenTec] Orion display readout


> Hi Martin,
>
> the RIT and XIT are obviously set at zero and this problem occur always 
> and in all modes.
>
> At zero beat in CW the matching frequency is 100 Hz lower on my display 
> and the same occur in SSB mode.
>
> If I use the 10 or 100 Hz step the the wrong display indication is still 
> present and I work always from front panel.
>
> So, this is the situation.
>
> Thank,
>
> Giuseppe IZ2ABU
>
> ------------------------------------------------------------------------------------------------------------------------------------
>
>  AGUSTA-WESTLAND
>  a Finmeccanica Company
>
>  Giuseppe CROSTA
>  c/o Politecnico di Milano
>  Galleria del Vento - Wind tunnel facility
>  Via La Masa, 34
>  20158 Milano - Italy
>
>  Phone   +39-02-2399.8057
>  Fax       +39-02-2399.8274
>
>  E-mail crosta at aero.polimi.it
> ------------------------------------------------------------------------------------------------------------------------------------
>
> Disclaimer :
> This e-mail is strictly confidential and solely for the addressee. Agusta 
> S.p.A. does not give any representation or warranty as to the accuracy or 
> completeness of  the contents of this e-mail,  nor shall the company be 
> held liable to any person resulting from the use of any information 
> contained in this e-mail and shall not  be  liable to any person who acts 
> or omits to do anything in reliance upon it. If you are not the intended 
> addressee you must not use, disclose or copy this transmission; in this 
> case, please notify us immediately by telephoning:
> +39-(02)-2399.8057
> Thank you
>
> Il presente messaggio deve intendersi strettamente confidenziale e 
> destinato esclusivamente al sopra riportato destinatario. Agusta S.p.A. 
> non garantisce l'esattezza e la completezza del messaggio così come 
> ricevuto e in ogni caso si ritiene esonerata da ogni responsabilità in 
> conseguenza di un'impropria utilizzazione del presente messaggio. Qualora 
> il messaggio Vi fosse pervenuto erroneamente, Vi è fatto divieto di usare, 
> diffondere o copiarne il suo contenuto. In tale caso Vi preghiamo di 
> volere immediatamente contattare il seguente numero telefonico:
> (02)-2399.8057
> Grazie.
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>