[TenTec] [orion565] 2.061f computer control problem

[John T. Fleming]

I found the same problem with Ham Radio Deluxe.  When I click on a DX spot,
it moves to that frequency, but will shows the original frequency until I
touch the knob.

 

73,

John

 

  _____  

From: orion565 at yahoogroups.com [mailto:orion565 at yahoogroups.com] On Behalf
Of Martin Kratoska
Sent: Thursday, May 17, 2007 4:58 AM
To: orion565 at yahoogroups.com
Subject: [orion565] 2.061f computer control problem

 

Dear Orioners,

since update to 2.061f a new problem appeared: if clicking onto spot in 
my favorite logging program the radio tunes properly, the program 
displays corect frequency but the main display on the radio stays on 
previous frequency. A short touch to main tuning knob corrects this 
problem, the main display jumps to the correct freuency.

Tested with Logger32 and xdx/xlog/hamlib in linux - both the same. No 
problems with 2.060b and below. Master reset does not cure the hanging 
display.

Anybody has similar problems?

Otherwise also noted a distortion on strong signals if the AGC response 
set to FLAT. I appreciate the NR function which shoes a significant 
improvement (compared to 2.060b). The CW sidetone artifacts also nearly 
completely (90%) disappeared.

73,
Martin, OK1RR