[TenTec] Omni 7 ethernet port and One Plug program problems?

[John Sheeley]

Denton 

  Join the Omni VII users group. Read through some of the earlier emails .There are a lot of work arounds for getting the OnePlug GUI  running .

http://groups.yahoo.com/group/Ten-Tec-Omni-VII/

Also download the OnePlug users guide.   If you haven;t already.

http://rfsquared.com/Updates/588/588 .
It's at the botton of the page


73
John WB4QDA

----- Original Message ----
From: Denton <denton at oregontrail.net>
To: Discussion of Ten-Tec Equipment <tentec at contesting.com>
Sent: Tuesday, May 22, 2007 8:53:09 AM
Subject: [TenTec] Omni 7 ethernet port and One Plug program problems?


Hi all..gotta a couple of problems with my slightly used Omni 7...and I 
don't think it's the rigs' fault.
When I try to run One Plug, I get a "run time error 13, type mismatch" 
message on screen instead of the programs start gui.
When I try to hook up a cross over ethernet cable to a second ethernet port 
in my pc to the Omni 7, the port and omni seem to talk to one another, but 
no data flows, irregardless of deligent internet address designation in the 
Omni's menu.
Any workarounds? will probably call TT later this am.... 


_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


       
____________________________________________________________________________________Yahoo! oneSearch: Finally, mobile search 
that gives answers, not web links. 
http://mobile.yahoo.com/mobileweb/onesearch?refer=1ONXIC