[TenTec] Gain Jumper Settings

[DGB]

Tnx for the replies, understood. I tried both settings and the high gave 
me the least loss. Thanks again.

73 Dwight NS9I

Alan Sewell wrote:
> I think you need to use the high position.  On an archived Inrad web 
> page it says concerning the filter curves:
>
> "The top graticule is labeled REF, and is normally 0 dB. The filter 
> insertion loss can be seen as the number of dB below the reference at 
> the center frequency."
>
> The #759 curve shows about 9 dB of loss.  The jumper high position is 
> for use with the Ten-Tec 216, 217 & 219 filters which have 8.0, 7.5 and 
> 10 dB of loss, respectively.
>
> 73,
>
> Alan  N5NA
>
> http://www.tentecwiki.org
>
>
>
> DGB wrote:
>   
>> I just put a #759 400hz cw filter in the 9mhz board. How does one know 
>> which gain jumper selection to use, high or low?
>>
>> thanks 73 Dwight NS9I
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>   
>>     
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>