[TenTec] Help with Orion II Update

[Carl Moreschi]

It sounds like you have a bad RUF file.  Download the update again from
RFSquared and start over.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "Ed" <w3etc at thecumminsgroup.com>
To: <TenTec at contesting.com>
Sent: Sunday, November 18, 2007 9:20 AM
Subject: [TenTec] Help with Orion II Update


> Hello Group:
>
>
>
> I am in need of some assistance. I went to update my Orion II, to the
2039J,
> last night and didn't get very far.  I have updated it before with no
> problem, but this time it would not update and the Orion screen displays
up
> to Program Flash 26 and then stops.  The software only executes to line
30.
>
>
>
> To make it more fun the radio will not perform a Master Reset and when you
> turn it on it just displays the Ten Tec logo.
>
>
>
> So it is stuck in a non operational mode.  It will go back in the flash
> update mode but that is it.
>
>
>
> Hopefully  it is not time for a trip home !
>
>
>
> Any suggestions would be appreciated.
>
>
>
> Thanks
>
>
>
> Ed  W3ETC
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec