[TenTec] Omvi VI AF Gain Control & RIT

[atrampler at att.net]

Thanks!

----- Original Message ----- 
From: "VE1BN" <ve1bn at eastlink.ca>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Sunday, November 18, 2007 6:00 PM
Subject: Re: [TenTec] Omvi VI AF Gain Control & RIT


> For Art ,K0RO,
>
> I copied an article in Contesting.Com that modified the range of the AF 
> pot
> in the OMNI 6+.
>
> This originated from Mark, K8VF, and I will pass it along to you and any
> others who want to do this.
>
> Don,  ve1bn at eastlink.ca
>
>> Put a 70 ohm , 1/8 watt resistor between wiper and af min on audio pot at
>  connector 55 on Lower pot board.
>
>  Did this on Lower pot board as it was easiest, you could pull the if/af
>  board, too but I did not.
>
>  Flip rig with bottom off and front toward you.
>
>  Lower pot board is on right front...connect 70 ohms(or so) between 2nd 
> and
>  3rd solder trace counting from the left.
>
>  Works like a charm. Normal audio level is at 12 o clock now instead of 7 
> o
>  clock........
>  I didn't have to pull any  boards either.
>
>  I can only guarantee this on my rig, not responsible for yours.
>
>  Best regards.<
>
>  Mark
>  K8VF
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec