[TenTec] Orion 1 slow to reach full output/muffled CW

[Duane Calvin]

That's what my Orion I did when I ran the 1.x firmware also.  Doesn't do
that with 2.x.

	73, Duane

Duane Calvin, AC5AA
Austin, Texas
www.ac5aa.com  
 

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Jon Zaimes AA1K
Sent: Thursday, November 22, 2007 8:24 PM
To: tentec at contesting.com
Subject: [TenTec] Orion 1 slow to reach full output/muffled CW

When I key my Orion 1 (v. 1.373b5) the red LED at first lights but then 
goes out as I key, and the signal sounds muffled on another RX.

When I hold the key down and watch an output meter, the output starts 
out low and then slowly rises to full output (and the LED comes on).

Any ideas what's happening? Adjusting the keying rise/fall has no effect 
on this problem.

73/Jon AA1K
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec