[TenTec] Tuning Rigs

ynkedragon at aol.com ynkedragon at aol.com
Mon Oct 1 09:44:02 EDT 2007


I have been using an manual tuner for years and would offer these 
thoughts:
1. I can usually tune the antenna matching unit close to resonance just 
by peaking received signal strength or band noise
2. Minimum RF output is almost always sufficient to achieve final 
resonance adjustments.
3. A chart of tuner settings, at about 100 KHz intervals can often help 
met avoid on-the-air tuning unless my antenna is coated with ice or 
otherwise off resonance.

73, Blair K3YD


-----Original Message-----
From: Ron Zond <k3miy at csonline.net>
To: tentec at contesting.com
Sent: Sun, 30 Sep 2007 4:39 pm
Subject: [TenTec] Tuning Rigs



Hi

I usually tune my jap rig (Yaesu FT 100) with an aototuner;
the foldback saves the finals. My Omni V requires the
time-tested method of adjusting the manual tuner for lowest SWR,
raising the power and repeating (just asi the pi networks did on the old
tube rigs).
If the SWR is too high, the 960 shuts down.
On the Yaesu, I use CW to tune the rig; much quieter (and legal; see FCC
rules about
superfluous communications).

Ron
K3MIY


_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


________________________________________________________________________
Email and AIM finally together. You've gotta check out free AOL Mail! - 
http://mail.aol.com


More information about the TenTec mailing list