[TenTec] Tuning Rigs

[Stuart Rohre]

Ten Tec's Tuner tuner Antenna noise bridge modulated with a tone, is a great 
way to tune up a tuner/ antenna combination to a 50 ohm match without 
putting the transmitter of your rig on the air.   The visual meter reading 
of the Antenna analyzer is replaced by the nulling of the tone in your 
receiver, that is produced by the Ten Tec bridge when off 50 ohm match. 
This is a quick way to do the matching, while you are visually watching the 
SWR meter or your tuner control settings.

You just have to be sure to not transmit into the noise bridge after you are 
tuned up.  Be sure to switch it out of the circuit going to the antenna 
tuner and antenna.

The kit was a one evening project and reasonable in cost.

-Stuart
K5KVH