[TenTec] Scout question

Bob McGraw - K4TAX RMcGraw at Blomand.net
Wed Oct 10 19:17:24 EDT 2007


An old fashion door buzzer operated on AC does about the same thing only 
"nasty-er"

73
Bob, K4TAX

----- Original Message ----- 
From: "Stuart Rohre" <rohre at arlut.utexas.edu>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Wednesday, October 10, 2007 6:06 PM
Subject: Re: [TenTec] Scout question


> Ten Tec told me the way they test the noise blanker for the Scout is to
> cycle a relay whose normally closed contact carries the initial power to 
> the
> relay coil..
>
> The normally closed contact wires power to the relay coil and when the 
> coil
> power is turned on by an external  switch, the relay pulls in breaking the
> power to the coil.  The coil releases the contact and it falls back,
> remaking the power connection to the coil.  Thus the relay continuously
> cycles until you turn off the switch.  The sparking of the contacts is 
> used
> as their standard of noise to be blanked.  They use a short wire on the
> antenna coax center connector, (on a banana plug) to act as antenna for
> noise pickup for this test.  This is easy to replicate with 12 volt supply
> and relay near the short antenna wire, and thus you can test your blanker.
>
> There are many noises the blanker will not help, like most "noise 
> limiters"
> or blankers on ham radio gear they are best for spark like impulses.
>
> -Stuart
> K5KVH
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 




More information about the TenTec mailing list