[TenTec] Orion 1 sub-receiver problem

Bob Cunnings bob.cunnings at gmail.com
Sat Oct 13 16:08:11 EDT 2007


I had a similar problem once - the sub-receiver would  work only
intermittently and when in the failed state generated a harsh noise.
After trying master reset etc. I finally "fixed" it by re-seating the
sub-receiver board and all of it's cable terminations and have had no
trouble since (2 years ago). It might be worth trying if all else
fails.

Bob NW8L

On 10/13/07, G.C. <g.crosta at tin.it> wrote:
>
> Dear all,
>
> I want to submit a problem occurred to my Orion I transceiver.
>
> The radio has installed the firmware version 2.062a with the v2 hardware modification to the Logic/DSP board.
>
> I haven't any problems with the radio since last week but now the sub-receiver seems dead and I listen only a bad noise.
>
> I realized that because the SPLIT function was ON and I don't listen nothing on one ear.
>
> I have re-loaded the software and initially the radio seems to work properly but after I switched off it the sub-receiver doesn't work at all.
>
> Nothing happen after a Master reset or Ram clear.
>
> So, I don't know what happen and I would like to know what I should do.
>
> Could you help me please? May I have a suggestion from your side? Did it already happen to anybody else?
>
> I thank you in advance for your attention.
>
> Best regards,
>
> Giuseppe CROSTA IZ2ABU
>
> P.S. I submitted this message also to Ten Tec service and I hope to receive some info from Paul.
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


More information about the TenTec mailing list