[TenTec] Omni VII Temperature Control

[Bob McGraw - K4TAX]

Alan:

Thanks for the info.  I needed to update the operating version from 1.019 to 
1.021.  Also did a update on the Boot Loader from 1.003 to 1.004 which is 
REQUIRED.  Updates were very easy and very fast and successful!

Thanks

73
Bob, K4TAX


----- Original Message ----- 
From: "Alan Sewell" <alan.n5na at gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Sunday, October 14, 2007 6:26 PM
Subject: Re: [TenTec] Omni VII Temperature Control


> Yes, there is.  Check the firmware history.
>
> Version 1.012
> Add Internal Temperature Control of approximately 70deg C
>
> Version 1.014
> Increase Over Temp Shutoff Temperature
>
> When 1.012 came out there were complaints of it shutting down when
> operating normally so the shutoff temp was increased in version 1.014.
> Maybe it needs to be bumped up a little more!
>
> This was apparently added to meet some European requirements.
>
> 73,
>
> Alan  N5NA
>
> http://www.tentecwiki.org
>
>
>
> Bob McGraw - K4TAX wrote:
>> Is there a high temperature TX shutdown in the radio?
>>
>> 73
>> Bob, K4TAX
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>