[TenTec] Audio quality issue in Heil headset with Omni V

k9mi at sbcglobal.net k9mi at sbcglobal.net
Mon Oct 15 18:25:47 EDT 2007


Rick,
I think it must be the monitor circuit in the rig itself as Barry pointed 
out.We are using exactly the same rig, and headset, and mine works fine. The 
slight hum I have occurs when either a) listening to a dead quiet band, or 
b) the tone control gain is set past 12 o'clock.

Good luck...

73, Mike K9MI



> Thanks for the replies so far.
>
> The questions led me to observe more carefully. The problem only
> occurs on the monitor, not on signals being received over the air.
> That opens the door to an impedance mismatch on the microphone or the
> phantom power issue. Or, as you suggest, a problem in the monitor
> circuit. I'll check these out.
>
> Rick, KR9D
>
> ---
> Richard W. Denney, Jr. PE|Iteris, Inc.
> Associate Vice President |107 Carpenter Dr. Ste 230 |    703.925.3819
> rwd at iteris.com           |Sterling, VA 20164        |Fax 703.471.1757
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 



More information about the TenTec mailing list