[TenTec] Centering Orion II Roofing Filters

Ron Castro ronc at sonic.net
Tue Oct 16 13:32:08 EDT 2007


I have an old 'boat anchor' signal generator that I use, but you can also 
use another rig running into a dummy load or a local ham you can hear on 
ground wave who can put out a dead carrier for a few seconds.  I found that 
no adjustment was needed, even on the 300 Hz filter.  After tweaking the 
settings, the defaults were still the best.

          Ron  N6IE
      www.N6IE.com


----- Original Message ----- 
From: "Harry G. McGavran Jr. " <w5pny at w5pny.com>
To: <tentec at contesting.com>
Sent: Tuesday, October 16, 2007 10:01 AM
Subject: [TenTec] Centering Orion II Roofing Filters


>
> It seems that one really needs a stable steady
> signal, both in frequency and level to do this job.
>
> Short of homebrewing a crystal calibrator (since
> these seem to be few are far between these days,
> even on ebay), what do people use for a good steady
> signal source for this job.  Off the air signals
> seem to have enough QSB to be a problem and without
> a second rig to use for a source, I was curious
> what other people used...
>
> 73,
>
> Harry, W5PNY
>
>
>
>
> -- 
>
> Harry G. McGavran, Jr.
>
> E-mail: w5pny at arrl.net
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 



More information about the TenTec mailing list