[TenTec] Jupiter display problem.

[Henry Mackey]

Mark,

My Jupiter has a fuse just below the connector for the DC power connection.

73 de Henry/n9hm

----- Original Message -----
From: "k8vf mark" <k8vf_mark at centurytel.net>
To: tentec at contesting.com
Sent: Sunday, September 2, 2007 10:53:21 PM (GMT-0500) America/New_York
Subject: [TenTec]  Jupiter display problem.

Thanks, Rick for the suggestion.

When I said "He says No"  I meant that those suggestions did not change the 
situation..I am sorry I was not clear.

I offered the power supply, power cord(suggested he put the meter to it and 
wiggle it), check all connectors ideas as I , too have seen the connectors 
pop off(filters, too-which is why I ship all TT rigs upside down).

None of those ideas has proven helpful in this situation.

I had him reset it multiple times..He says the rig will now transmit, but 
screen is very dim..

I have seen no previous queries about the screen being defective(other than 
some initial questions as the rig was coming to market)


If I remember correctly, there is no brightness control, just a contrast 
control..

We are both being gentlemen, we have no problems between us. The rig worked 
the first day and next day it did not.
He will be contacting TT service for advice, perhaps they have seen this 
before. Naturally we both hope so.


Is there an internal fuse in the Jupiter?  Perhaps it has worked loose?
I dont have the rig to check-is there a fuse?

Thanks a lot folks, I sure appreciate it.

Mark


_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec