[TenTec] Ten Tec 238A settings?

[Denton]

Remember those little ceramic blocks that were used for tv twin lead for 
lightning protection? I took one apart...two high value resistors inside.
----- Original Message ----- 
From: "Bob McGraw - K4TAX" <RMcGraw at Blomand.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Sunday, April 13, 2008 7:50 PM
Subject: Re: [TenTec] Ten Tec 238A settings?


> Didn't have an arrestor on the outside, eh.  Folks that put up antennas 
> need
> to understand the need for lightning protection systems.  I've found that
> most don't........understand.  Many take shortcuts and omit critical
> components and configurations.  Lightning can be extremely nasty but it
> doesn't have to be such.
>
> 73
> Bob, K4TAX
>
>
> ----- Original Message ----- 
> From: "Ed" <w3nr at comcast.net>
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
> Sent: Sunday, April 13, 2008 3:15 PM
> Subject: Re: [TenTec] Ten Tec 238A settings?
>
>
>> Denton wrote:
>>> Ahhhhhhh...success! Ran 600ohm feeders all the way to the tuner in the
>>> shack! Since there is no wiring in that part of the ceiling, I just
>>> screwed
>>> some cuphooks on the ceiling and suspended the feeders in them.
>>> Preliminary
>>> tuning is nice and smooth.
>>
>> I did that once.....after $23,000 worth of fire damage from a direct
>> lightning strike that followed the open wire feeder into the house.
>>
>> Be  careful and take precautions.    73
>>
>> Ed W3NR
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>