[TenTec] Omni 6 Plus Repairs

Speer, Doug Doug.Speer at FairbanksMorse.com
Thu Apr 17 15:07:18 EDT 2008


I am a new to Ten-Tec owner of an Omni 6 Plus.  The rig purchased from the estate of a silent key had been in storage for about 7 years.  When I bought the rig and powered it up the receiver appeared to work fine however the transmitter would not do more than 20-25 watts on 160 and 80m.  40m and above would run from 80-100 watts.  On 160 and 80m the total current draw on the power supply was less than 10 amps.  I sent the rig to Ten-Tec for repair and they replaced the Finals and Drivers at a cost over $450.  I'm curious from a technical view if replacing finals would seem to be the right fix.  I would expect problems with the higher frequency not lower frequency bands if the Finals were bad.  

Any comments or thoughts out there?

Doug, W9PN

 

----------Legal Disclaimer---------- 

The information contained in this message may be privileged and confidential, and is intended solely for the use of the named addressee. No other person is authorized to access, copy or re-use this message (or any information contained herein). If you are not the intended recipient, please notify us immediately by replying to this message and delete it from your computer. 




----------Legal Disclaimer----------

The information contained in this message may be privileged and confidential, and is intended solely for the use of the named addressee.  No other person is authorized to access, copy or re-use this message (or any information contained herein).  If you are not the intended recipient, please notify us immediately by replying to this message and delete it from your computer.



More information about the TenTec mailing list