[TenTec] Argonaut 509

[k4zm at comcast.net]

Bill:

I think I have a 509 Manual if you would like I will scan it and convert to a PDF file and email it to you.
In fact I have copies of most all the Ten Tec Gear manufactured in the 70's and 80's.

73
Jim Younce K4ZM

-------------- Original message -------------- 
From: "Bill Ames" <billa at aob.com> 

> 
> 
> I have finally located some of the "green" non toxic cleaning stuff (thank 
> you to all who pointed me in this direction) and obtained some cotton balls. 
> Next is the removal of the knobs. I do not have a manual for this rig but I 
> am sure that there is some important information I should know before I 
> attempt this next step. I would like to know what type/size tool I will need 
> to properly access the knob set screws; I don't want to strip them. I should 
> probably take the cover off and see if anything is living in there :-( but I 
> don't think so. Any suggestions are appreciated. 
> 
> 
> 
> Bill 
> 
> 
> 
> KB1LG 
> 
> 
> 
> Bill Ames 
> Analytica of Branford, Inc. 
> 29 Business Park Drive 
> Branford, CT 06405 
> PH: (203)488-8899 xt 337 
> 
> 
> 
> 
> 
> _______________________________________________ 
> TenTec mailing list 
> TenTec at contesting.com 
> http://lists.contesting.com/mailman/listinfo/tentec