[TenTec] Help with a probably stupid question

[n4py at arrl.net]

There are 12 torque screws you have to remove from the back.  All these are 
along the edge of the cover on the back of the radio.  Then each cover has 4 
large side screws to remove.  That's it.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "Bruce McLaughlin" <bmclaugh at bex.net>
To: "'Discussion of Ten-Tec Equipment'" <tentec at contesting.com>
Sent: Wednesday, August 06, 2008 7:04 PM
Subject: [TenTec] Help with a probably stupid question


>I have been having problems with RF getting into the headphone line of my
> Orion II when its operated with my linear amp.  There is no problem with
> transmitting. Ten Tec was kind enough to send me a little circuit board 
> with
> instructions on how to install it.  Unfortunately, the instructions did 
> not
> include how to remove the top and bottom covers.  Neither does the owner's
> manual.  I see a number of small screws running along the back edge of 
> both
> the bottom and top covers along with two large screws on each side. The 
> back
> cover screws are removed with the wrench included with the rig.
>
> I assume those screws should be removed but I want to be sure I remove 
> only
> the necessary screws and not something which should not be removed.
>
> Can anyone help me.  I am particularly interested in knowing how many of 
> the
> back edge screws should be removed, etc.
>
> As I said . . . I realize this is probably a stupid question but then 
> again
> when it comes to such questions I have no shame.  Thanks for any advice.
>
> Bruce - W8FU
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec