[TenTec] Experience with 300 HZ filter in Orion II?

[John]

Thanks Ron....that's what I was looking for.  It probably also drops the 
noise a tad for that weak signal stuff on 160.

I found I was using the 250 Hz in my Orion even with the insertion loss.  It 
allowed for less noise than the 600 Hz INRAD in the 1 Khz slot.

73 John K4NP
----- Original Message ----- 
From: "Ron Castro" <ronc at sonic.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Wednesday, December 03, 2008 2:39 PM
Subject: Re: [TenTec] Experience with 300 HZ filter in Orion II?


> John:  I have both in my OII, but the 300 Hz is the one I use the most. 
> In
> the contest this past weekend, I found myself running the DSP at 200 Hz
> under the 300 Hz filter.  I can hear the difference when I change BW from
> 300 Hz using the 300 Hz filter and 310, which forces the 600 Hz filter. 
> If
> you contest a lot, the 300 Hz filter is worth the investment.
>
>         Ron  N6IE
>      www.N6IE.com
>
>
> ----- Original Message ----- 
> From: "John" <fraz1 at bellsouth.net>
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
> Sent: Wednesday, December 03, 2008 10:12 AM
> Subject: [TenTec] Experience with 300 HZ filter in Orion II?
>
>
>>I have the 600 Hz filter installed.  Anyone have good experience with the
>>300 vs 600?
>>
>> 73 John K4NP           fraz1 at bellsouth.net
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec