[TenTec] Orion II reset

[N4PY]

First do a battery reset.  With power initilally turned off.

1) Hold the VFOB LCK button and power on.
2) Keep holding until you see "Battery Failure".

Then do a master reset.
1) Hold the "Main TX/RX" button and power on.
2) Select YES to clear all memories.  ( This must be done after a battery 
reset or all your band registers will be zero.)

After the above is done, do one more power off and back on.  This clears out 
everything and starts fresh.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "John" <brazos at rochester.rr.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Thursday, December 04, 2008 5:45 PM
Subject: [TenTec] Orion II reset


> Hi All !  can someone please tell me how to perform the most detailed 
> reset
> on the OII not just the standard one I forgot how and did not write it 
> down
> thanks .  John kb2huk.
> ----- Original Message ----- 
> From: "Paul DeWitte" <kb9lie at gmail.com>
> To: <tentec at contesting.com>
> Sent: Thursday, December 04, 2008 8:46 AM
> Subject: [TenTec] Corsair II thump
>
>
>> Last night I put new wiring (#10 wire) from the power supply to the 
>> radio.
>> Much shorter and only connections are for the breaker and the ends.
>> Soldered
>> all connections, and now all seems OK. Thanks to all for the responses 
>> and
>> suggestions.
>>
>> 73 Paul K9OT
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> -- 
> I am using the free version of SPAMfighter.
> We are a community of 5.7 million users fighting spam.
> SPAMfighter has removed 1194 of my spam emails to date.
> Get the free SPAMfighter here: http://www.spamfighter.com/len
>
> The Professional version does not have this message
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec