[TenTec] Omni VI Opt 3 Audio Problem

[John Cox]

I had a similar problem and found that by turning the pass band knob 
slightly it would go away.  usually showed up on power on.
73, john
kc0yai
----- Original Message ----- 
From: <atrampler at att.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Sunday, December 07, 2008 7:20 AM
Subject: [TenTec] Omni VI Opt 3 Audio Problem


Intermittently I lose most of my RX volume, both from the speaker/headphone 
jacks and the line out.

Sometimes turning the rig on and off will cure the problem.

In short, I have audio, but very low, and the volume controle does nothing 
till wide open, and then I have only white noise.

I believe it is in the DSP board or a relay to it, because I totally lose 
sidetone, spot tone, and features such as the automatic notch filter and DSP 
audio filters.  The manual notch filter still works.

Anybody experience this and have a suggestion?

Art, KØRO
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec