[TenTec] 705 Mic Low Output Help Request

[David & Chris Drake]

Don't remember for sure without looking it up.  But I think 9-12v.  The mic
runs off a 9v battery if not getting power directly, so it would make sense
it needs around 9v to work.
David

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Greg Kuczek
Sent: Monday, February 04, 2008 9:15 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] 705 Mic Low Output Help Request


I'm running it thru the jack. I haven't checked the voltage at the jack yet,
thanks.  Do you know what the voltage should be?
   
  73
  Greg W9VOX

David & Chris Drake <drakes at psci.net> wrote:
  Are you running the 705 by battery or through the Omni V? If through the 
Omni V, check the voltage at the jack first. If by battery, check the 
battery. Then check the plug before going inside it.
Good luck,
David

----- Original Message ----- 
From: "Greg Kuczek" 
To: 
Sent: Sunday, February 03, 2008 10:23 PM
Subject: [TenTec] 705 Mic Low Output Help Request


>I have a 705 mic that I am having low output problems when used with an
>Omni V. I've read that you can change out the R11 resisitor to 3300 ohms to

>help correct this. Unfortunately I don't have a schematic or any 
>documentation to help me locate this resistor. Any help identifying R11 
>would be appreciated.
>
> 73 de Greg W9VOX _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> 


_______________________________________________
TenTec mailing list
TenTec at contesting.com http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec at contesting.com http://lists.contesting.com/mailman/listinfo/tentec