[TenTec] Omni V no receive on 40m

[Bwana Bob]

Scott,

I would look around the heterodyne crystal for 40 m or perhaps the 
crystal itself is bad.

				73,

				Bob WB2VUF

scottsheppard at videotron.ca wrote:
>  
> I have an issue with my Omni V. It now seems when I turn it on (cold) I do not get a receive signal on 40. If I hit any of the other band buttons the receiver comes to life, back to 40 nothing. After about two minutes it finally comes on. I have done the little switch check at the back to no aval and given the other bands still work it is most likely not it. I have poked a proded but nothing yet. This is a relatively new issue. Again, only on 40. Any suggestions appreciated.
>  
> 73  scott VA3IED
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
>