[TenTec] 962 Power supply Bridge rectifier needed

[Dr. Gerald N. Johnson]

On Tue, 2008-01-01 at 20:20 -0600, Bob McGraw - K4TAX wrote:
> How about this:   GBPC3501  $2.92 in single lot qty.  From Mouser
> 
> Manufacturer data sheet:  http://www.fairchildsemi.com/ds/GB/GBPC3501.pdf
> 
> 35amp, 100 PRV.   It is a real generic non-critical part.  Now what's 
> critical is to clean the bottom of the power supply where the bridge block 
> mounts, make sure you have some good heat sink compound but not too much and 
> bolt the sucker in tight with the center mounting screw.    If you choose, 
> use the crimp on spade lugs but do solder the wires to the female spade 
> terminals.  When pushing the lugs on, make sure they are tight and snug. 
> Otherwise if you have a suitable soldering iron, solder the wires direct to 
> the bridge block.
> 
> 73
> Bob, K4TAX
> 
Now he says it plugs into the PC board and the NTE lugs don't line up
with the slots in the board. In the NTE catalog I see two post
arrangements and one with round wires. I can't tell from here which
fits.

73, Jerry, K0CQ