[TenTec] 962 Power supply Bridge rectifier needed

[Dr. Gerald N. Johnson]

On Wed, 2008-01-02 at 02:16 -0500, Lew wrote:
> Yes, I removed the blown block from the 962 supply. It indeed
> was soldered directly through  the circuit board. I kept solder
> sucking the solder off then finally cut the terminals off the
> bridge and reheated each terminal to remove. Was not a fun job but
> worked fine!  So, if one wants to put a bridge back stock,  the pins
> must line up exactly with the board. I had some bridges (generics)
> here and the pins do NOT line up. I can hard wire it  no problem but,
> if I can find a match, it would be a good way to do it. In the mean
> time, my Astron RS35M is doing the job nicely. 73 Lew K1NDV
>  
> -------Original Message-------
>  
> 
> 
Have you looked at the alternative pin arrangements at www.nteinc.com? I
think not. They do have three variations. One with round wires almost in
a square, and two with flat spade lugs. One arranged:

| |
| -

and one arranged
-|
|-

73, Jerry, K0CQ