[TenTec] ORION II TX gone

[Barry N1EU]

Do you have the keying loops turned off and the Transmitter turned on
in the TX Menu?

73,
Barry N1EU

On Wed, Jul 30, 2008 at 8:06 PM, Tõnno Vähk <Tonno.Vahk at gildbankers.com> wrote:
> Hi, I have lost any TX output from OII. Pwer can be turned up to 100w but no TX out in any mode, everything else seems normal. RX seems to be OK. I saw some messages in archives looking for solution to the same issue but no cure. Tried Master reset and also reinstalled firmware, no change. Is there anything I can try or should I send it to repairs?? Has it been established what the problem is?