[TenTec] OmniVI Plus Over Drive Amp

Duane Calvin ac5aa1 at gmail.com
Sat Jun 14 14:32:45 EDT 2008


Is that 300W out RMS or peak?  If it's RMS, you're really pushing it HARD!
If it's peak reading meter, you're probably still pushing it.  If it's LED's
then maybe you have a concern. (I can't recall if the Herc II has the LED PO
o rnot - and even if it does, you should check it against a known accurate
PO meter.  Just a thought.

	73, Duane

Duane Calvin, AC5AA
Austin, Texas
www.ac5aa.com  
 
-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Jim WA9YSD
Sent: Saturday, June 14, 2008 1:05 PM
To: tentec at contesting.com
Subject: Re: [TenTec] OmniVI Plus Over Drive Amp

Think I got it now.  Porcessor OFF.
Adjust Mic gain untill ALC lights on peaks.
Turn on Processor Switch Meter to Processor speak into mic untill meter in
HEAVY in Black Area.

Settings
are completely Different from where I had it.   Is this the Best DX
punch I can get?  How can I tweak settings better for a better punch
before I start flat toping the audio or sound distorted?

Still OVERDRIVE light on Hercules II still lights up 300 watts plus out.
Power does not go into Red area.  I have to back Mic gain down to 75Watt
peaks so OVERDRIVE does not light.  My conclusion is to ignore this
condition.  Is this OVERDRIVE light too sensitive and needs adjustment or
what do I need to do?

 Keep The Faith, Jim K9TF/WA9YSD



      
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



More information about the TenTec mailing list