[TenTec] OmniVI Plus Over Drive Amp

[Ken Brown]

What do you mean by "300 watts out on SSB"? How are you measuring it? 
300 watts indicated by a slow responding D'Arsonval meter movement, 
could be 500 watts peak. If you can get 450 watts CW from the Hercules 
II, before to overdrive light comes on, then it is probably working fine.

The procedure is to go to CW mode and adjust the RF power output of the 
Omni VI to just under the level that lights the overdrive LED. Then in 
SSB mode adjust the mic gain for ALC LED lighting on peaks. This 
procedure should result in SSB peaks no higher than CW output power 
level, and consequently no OVERDRIVE LED lighting.

If you have set the PWR control on the Omni VI such that CW drive power 
level does not light the OVERDRIVE LED, and then in SSB mode the 
OVERDRIVE LED does come on, the problem is likely in the ALC adjustments 
in the Omni VI and not in the Hercules II.
> I kept speaking into the mic and turned down the power drive on the OMNI VI Plus until the OVERDRIVE led on the Hercules II stopped popping on.  That point was 300 watts out on SSB.  This situation only happens on SSB not on CW. 
DE N6KB

>