[TenTec] 32 bit N4PY Software coming soon

[n4py at arrl.net]

There is an SSBRTTY.DAT file that allows you to define the digital area 
inside the CW area.  Defining this file properly addresses the exact issue 
you are talking about.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: "Paul" <designer at quickdata.com>
To: <tentec at contesting.com>
Sent: Tuesday, June 24, 2008 8:21 PM
Subject: Re: [TenTec] 32 bit N4PY Software coming soon


>I vote for another column of buttons like those for CW SSB and SWL.
> Maybe call it Digtl for digital. Instead of a freq. range like the
> others, it would just take a point - like 14.070. Or....it seems to
> me when the program was first designed. modes where well defined. You
> had your CW portion and your SSB portion. But now, the CW portion can
> be split with an island of Digital Mode in the middle. Problem is,
> when  you key in the frequency and it is in the middle of the CW
> min/max frequencies, the mode jumps to CW.
>
> So it looks like the logic has to be reworked a little to allow for
> the split and provide the same clear graphics. Like the CW portion of
> 40M in green tic marks up to a defined "bottom" of a digital segment,
> then another color for the digital segment (or special tic mark if
> single frequency) up to the digital Max for that band, then the tic
> color changing back to CW green (or is it blue).
>
> My point is - instead of different band modes living side-by-side
> with non-overlapping start/finish points, now you have modes spliting
> the band segment of other modes - like CW and digital modes/segments.
> It would be great if a new version addressed that in the frequency
> display and "convenience" buttons.
>
> 73,
> Paul
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec