[TenTec] [Fwd: Re: Status of New Display Board for OMNI VII]

Carl J. Denbow n8vz at qth.com
Tue Nov 18 22:44:11 EST 2008


Since it's now almost December and there's no indication that this board 
is going be produced by the time Dayton rolls around in 2009, I thought 
I'd bring this old message back up to the top again.  In my book, this 
is not a good mark on the Ten-Tec record.  -- 73 de N8VZ

-------- Original Message --------
Subject: 	Re: [TenTec] Status of New Display Board for OMNI VII
Date: 	Sun, 17 Aug 2008 18:40:06 -0400
From: 	Carl J. Denbow <n8vz at qth.com>
Reply-To: 	Discussion of Ten-Tec Equipment <tentec at contesting.com>
To: 	Discussion of Ten-Tec Equipment <tentec at contesting.com>
References: 	<48A887E7.9060308 at qth.com> 
<BC9DDA74-65C3-4F5E-A8F4-1E74C8C60418 at bellsouth.net>



Thanks, Mike. If this is not an old, not-updated post, I was lied to at 
Dayton.  I was shown a prototype board and was told it was ready for 
production.  In fact, I was told that the week after Dayton they would 
be having a production meeting and that the board would be ready for 
general sales within three months or so.  A friend of mine who bought an 
ORION II about three years ago was told at that time that the board 
would be ready "in a few months."  He's ready to ditch his Ten-Ten 
equipment he is so mad about this issue.  When I gave him the 
information from Dayton, including my live sitting of the prototype 
board, he calmed down a little and said he'd give Ten-Tec a few more 
months.  In short, I hope what I was told at Dayton is more accurate 
than this link.  Perhaps, at this juncture Ten-Tec's recent "sins" are 
no more than not updating a web page! :-)

Mike Christiansen wrote:
> Check this link at the Tentec site.  it should answer your questions
>
> http://radio.tentec.com/status/
>
>
> On Aug 17, 2008, at 4:19 PM, Carl J. Denbow wrote:
>
>   
>> Does anyone know the status the new display board that is coming out  
>> for
>> the OMNI VII and ORION II?  I saw a prototype at Dayton and was  
>> assured
>> that it was ready for production.  This board will allow, among other
>> things, for real time, continuous spectrum scope (like the ICOM 756  
>> pro
>> series has).  I'm really looking forward to this new board, which is
>> supposed to cost in the $300.00 range.
>>
>> Carl
>> N8VZ
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>     
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>   
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec





More information about the TenTec mailing list