[TenTec] Jupiter fimware Rev 1.30

Henry Mackey kb9cqo at embarqmail.com
Sun Oct 26 15:01:38 EDT 2008


Belay the following.

I have found new info, which I HAVE NOT READ!

Thank you.

73 de Henry/n9hm
                         =================================

----- Original Message -----
From: "Henry Mackey" <kb9cqo at embarqmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Sunday, October 26, 2008 2:39:18 PM (GMT-0500) America/New_York
Subject: [TenTec] Jupiter fimware Rev 1.30

Would the group please lend a hand in upgrading the Jupiter? If there is a way to be confused in handling anything it seems my bad luck lately to find that way. 

The 538KBD.RUF file was used to upgrade the rigs firmware. Following this the chip received from TenTec was installed replacing the previous chip. The screen now states, upon recycling the power, "Rev 1.30 b3 08.21.2008".

I am going to skip how I understood, or misunderstood, the instructions following this point. The power was cycled, but I see no difference in the new screen. 

What am I to do with the disc that came with the chip from TenTec? I see no instruction concerning this disk either in the box or in the software instructions received via the web.

73 de Henry/n9hm
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



More information about the TenTec mailing list