[TenTec] OMNI V Problem Growing...

[waltk8cv4612amos at att.net]

Have you tried a wooden stick to poke around on the boards?

Heat from hair dryer?

Cold from a spray can ?

I think TenTec press fits wires into there plugs and they may be needing a 
re-seat too?

Could be a cracked trace, but more likely a bad solder joint that looks just 
fine.

Walt K8CV Royal Oak, MI.

----- Original Message ----- 
From: <OTAKEBI at aol.com>
To: <tentec at contesting.com>
Sent: Wednesday, September 03, 2008 12:15 AM
Subject: Re: [TenTec] OMNI V Problem Growing...


> No problem with that Joe.
> This is a brain buster.
> Can't get it to stay dead to trace it.
> Dan/N4VET
>
>
>
> **************It's only a deal if it's where you want to go. Find your 
> travel
> deal here.
> (http://information.travel.aol.com/deals?ncid=aoltrv00050000000047)
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec