[TenTec] Rebuild 509 PTO

[Wally]

After posting this question I went back and 
touched the ball bearings with the razor and 
they all came out. I guess the grease lighting 
finally soaked in and loosened the grease.
73 back to the rebuild.
Wally

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of w1ioo at cooledge.com
Sent: Saturday, September 06, 2008 2:34 PM
To: tentec at contesting.com
Subject: [TenTec] Rebuild 509 PTO

I have the rebuild kit from TenTec. Following the directions everything was
going fine till I had to remove the ball bearings. They won't come out. I
have tried alcohol and Grease Lighting. This product seems to melt the
grease. No luck. They just seem to be stuck in the brass. I was thinking of
a little heat from a soldering iron might loosen them. Would like some ideas
before I destroy it. Thanks in advance.

Wally w1ioo  

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec