[TenTec] How do I select BC frequencies?

[Martin Ewing]

Not quite right!  You have to use the sub-receiver, which is general
coverage.   The sub-receiver can be controlled by either VFO A or B.
But you have to be sure the main receiver is not also on the same VFO,
because that limits you to ham bands only.

I have grumbled over the years about how TT designed the two VFOs and
receivers.  It's all very flexible, but there are too many modes when
all I want are two or three different configurations, at most.

73 Martin AA6E

On Mon, Apr 27, 2009 at 11:53 AM,  <KM4BSHAM at aol.com> wrote:
> Hi Rick, You can only enter and listen on vfo-B.  73 Dave KM4BS
>
>
> In a message dated 4/27/2009 11:52:25 A.M. Eastern Daylight Time,
> nq4i at contesting.com writes:
>
> Hi  all.... I know I will feel stupid after I learn that it is easy, but the
> sb  rxcvr in the Orion is supposed to cover from 500khz up to 30mhz...how do
> I  enter and listen to Broadcast frequencies??
>
> 73 and thanks de Rick  NQ4I
> _______________________________________________
> TenTec mailing  list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> **************A Good Credit Score is 700 or Above. See yours in just 2 easy
> steps!
> (http://pr.atwola.com/promoclk/100126575x1220572846x1201387511/aol?redir=http://www.freecreditreport.com/pm/default.aspx?sc=668072&hmpgID=62&bcd=
> Aprilfooter427NO62)
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>